My Design Plans: https://jonpeters.com/design-plans/
My Tool Store: https://www.acmetools.com/shop/tools/…
My Shop Talk Channel: https://www.youtube.com/watch?v=6Rf7yXNpVmE
This is a simple Jig to make and works great for making repeatable mortises. The table I’m building will have a cross brace in the center made with a lab joint. The cross brace will connect to the legs with 2 inch mortise and tenon joints.
1. I start by ripping two strips of wood at three eights of an inch And then a larger piece for the center at about an inch and an eighth.
2. I attach the pieces back together leaving a 4 inch gap on one side to create a guide for the router.
3.Half-inch plywood shoulders are attached to the center piece.
4. The jig slips over the work piece and is clamped into position.
5. To cut the mortises I use a Stagger Tooth plunge cutting bit in a plunge router.
6. Four Perfectly cut mortises.
Stagger Tooth Bit: https://www.toolstoday.com/stagger-tooth-plunge-cutting-router-bits.html
Merchandise: https://jonpeters.com/store/
Instagram: https://www.instagram.com/jonpeters_
Facebook: https://www.facebook.com/JonPetersArtHome/
Support This Channel On PATREON: https://www.patreon.com/jonpeters
Makers Mob Woodworking School: https://www.joinmakersmob.com/jon-peters/
Subscribe to my other YouTube Channels:
Jon Peters Shop Talk: https://www.youtube.com/watch?v=6Rf7yXNpVmE
Make It In Vermont: https://www.youtube.com/channel/UCRla1KkfYs9TSaz5B7doK-Q
Two River TV: https://www.youtube.com/channel/UCxW4iVALiHXASzPII1UIvrA
Apparel: Mountain Khakis
http://www.mountainkhakis.com/
Rugged. Authentic. Reliable. Timeless.
